Replacement valve for NRS Float Bags. No adhesive necessary. Use heat to soften 1/2" plastic tubing when removing old valve and installing new valve.
Quantity:
No more pumping with one hand and holding the hose with the other! A quick twist seals the Leafield C-7 Valve Adapter to your boat's Leafield C-7 Valve for easy solo inflation with zero leakage. This adapter is especially helpful with high-pressure drop-stitch inflatables such as the NRS Big Earl SUP…
Quantity:
…strong and abrasion-resistant while still being very lightweight. Each of the tube chambers has a large opening, inflation/deflation valve and a second smaller twistvalve for top off and pressure adjustment. Four front and two rear webbing tie-down points let you securely lash on packs and other gear…
Quantity:
…When you've pushed as much air in the tube with the Fill Bag as you can, remove the Bag, close the valve and bring the PackRaft up to full operating pressure by blowing more air into the small twistvalves.
Quantity:
…draw cord. Constructed with a durable nylon outer shell with two inch webbing grab loop (not shown). Dual air chamber design with easy-to-use twistvalves provide you with a back up chamber if ever necessary. Reflective tape for additional visibility. Note: You only need to inflate one of the air chambers…
Quantity:
…pressure is required and pumping becomes difficult, just a simple twist of the handle locks in the the high-pressure top-off stage. There's an adapter for Leafield valves and a universal adapter that fits Halkey-Roberts and most other boat valves. The pump is easy to operate by one person. There are no hoses…
Quantity:
…to become difficult, a simple twist of the handle locks out the high-volume primary stage and locks in the high-pressure "top-off" stage. Nozzle end and included adapters fit most inflatable boat valves - Leafield, Halkey-Roberts, Summit, Boston, AD-2 and military valves. Ergonomic design is comfortable…
Quantity:
…with a simple twist of the wrist you switch to the high pressure mode, where you can achieve up to 25 psi. The K-20 HP weighs in at a mere 2 lbs. and is 21 1/2 inches long. .There's an adapter for Leafield valves and a universal adapter that fits Halkey-Roberts and most other boat valves. Ergonomic design…
Quantity:
…chamber increases and pumping starts to become difficult, a simple twist of the handle locks out the high-volume primary stage and locks in the high-pressure "top-off" stage. Nozzle end and included adapters fit most inflatable boat valves - Leafield, Halkey-Roberts, Summit, Boston, Military and AD-2. Ergonomic…
Quantity:
…sturdy handle and tough polypropylene housing are built to withstand lots of use. The pump comes with a twist-fit C7 Leafield Valve adapter and a full set of adapters for other types of valves. Each full stroke puts out 0.60 gallons (2.3 liters) of air.
Quantity:
…you on the water. It also deflates making it quick and easy to get your inflatable packed back up. Comes with an adapter to fit a wide variety of valve types. Inlayed rubber insulates from heat and sound while providing a more secure grip. 12 foot power cord allows you to easily inflate your boat near…
Quantity: