Replacement rubber feet for the NRS Gusto pump.
Quantity:
The Rubber Oar Stopper keeps your oar shaft from sliding through the oarlock. Fits both Carlisle and Cataract oar shafts. The 1" thick rubber stopper goes right over the oar shaft, not over the Molded Oar Sleeve. The 1 5/8" inner diameter is a tight fit on the shaft. Use either soap and water or hair…
Quantity:
Replacement O-Ring for the 4" or 6" older model Carlson Hand Pumps. Carlson used the Rubber O-Rings pre 2004. If your pump has a green hose, it is an older model and should utilize the Rubber O-Rings.
Quantity:
PVC/Urethane adhesive with accelerator. Can be used to bond PVC to rubber (Hypalon®, neoprene, Pennel Orca®etc). When bonding rubber to rubber, Clifton Hypalon Adhesive, #1904, is your best choice. Coverage Guidelines: 4 ounces should cover 1 - 1.5 sq. ft. of patch (both surfaces), with 2 thin coats…
Quantity:
Extra Pin for the Pin and Clip Setup. 9" Pin Assembly comes with rubber bumper on top, one 3 1/2" PVC bushing, two washers and a nut. 12" Pin Assembly comes with rubber bumper on top, one each 1", 2" and 3 1/2" PVC bushings, three washers and a nut.
Quantity:
…featuring a thinner, more lightweight sole and a softer footbed. The EcoTread™ lugged rubber sole has been siped for additional traction, especially on wet surfaces. EcoTread is composed of 25% recycled rubber for a lighter impact on the environment. The polyurethane upper is softer than traditional…
Quantity:
…featuring a thinner, more lightweight sole and a softer footbed. The EcoTread™ lugged rubber sole has been siped for additional traction, especially on wet surfaces. EcoTread is composed of 25% recycled rubber for a lighter impact on the environment. The polyurethane upper is softer than traditional…
Quantity:
Replacement military valve for Riken and Achilles boats. Plastic construction with a six-hole mounting pattern that holds valve in a recessed rubber boot. Standard size replacement. Screws not included. Outside diameter of the valve flange is 2-3/16 which may fit better in some valve boots.
Quantity:
Simple and effective valve that has been in the industry for many years. Six-hole mounting pattern holds valve in a recessed rubber boot. Standard size replacement. Screws not included. Outside diameter of the valve flange is 2-3/8.
Quantity: